Thursday, April 23, 2020

Root 3 CNC - Power Switch

To increase safety, an emergency power switch was installed on the 12v power supply for the Arduino/RAMPS board (another will be added later for the spindle).



Wire clamps were added to the box:


110V power cable routed through box:


Removed plug from 12V Power Supply cable:
 

Wiring Diagram for the Powertec:


Connected wires to the screw terminals:


Added electrical tape to cover the screws for safety:


12V power supply connected:


Wires routed and switch connected to the cart:


No comments:

Post a Comment