While looking through online sources, many people hand-cut a notch in the X-Axis 3mm Belt Mount in order to simplify belt-tightening. Rather than cut into the exist part, measurements were taken from the provided STL file and a modified version was created. The modified file can be found on
Thingiverse.
Comparing the two parts:
The new part is on the left. A notch has been added for the timing belt, as well as a few other minor changes. All edges have been rounded, and the right side opening narrowed a bit to get the M3 screw holes a bit further from the edge. The final part can be seen below.
No comments:
Post a Comment