Root 3 CNC - Running power for the VFD

In order to run the VFD/Spindle on a second circuit, another power cable and cutoff switch was purchased.  This is basically the same process used when running the power for the Arduino/RAMPS/motors, only with larger gauge wires.

The components used were:

• 12/3 SJOOW cable from Home Depot
• 12/3 extension cable from Amazon (this is a 20A cable incorrectly labelled as 15A)
• Powertec 71007 Paddle Switch from Amazon
• 1 gang weatherproof box from Amazon

First the wires were pulled into the box, and ring terminals soldered onto the ground wires:

The ground wires were connected to the box:

Hot and neutral wires were run to the switch screw terminals, and covered with electrical tape:

The screws that come with the Powertec cover are not compatible with US boxes.  They were discarded and replaced with standard outlet cover screws:

Finally the cover was installed and mounted to the CNC cart: